Connect-Tek Transa PRO 17 Manuale delle Istruzioni Scaricare il pdf (Pagina 118)

5.3.2. Material Requirements

R analog output requirement

1 TACHTROL 10 (TT10): Use for displacement

s for tachometer

inst

1 AI-TEK D ustrative purposes. Use

encoder wh e

strument configuration can be done on the bench and tested using Verify and

nect power per section 3.4.2.

ACHTROL 10 and 30 per

• Connect sensor to TACHTROL 10 and 30. Parallel A Sig, B Sig and

Directi l section 3.3.2.

• Connec

• Connect alarm Relay 1 & 2 from TT10 to speed alarm per section 3.3.2.

igital 1 & 2 from TT30 to displacement alarm per section

5.3 Setup (Displacement)

Thi to run in Counter mode and configured to monitor

tage. Since the stage will be moving in

two e will be employed to track the increase and

decrease of pulses generated by the sensor, that translate into the relative

lished either through the TT

disp

1 TACHT OL 30 (TT30): Use for speed with

2 TACHTROL

plus

(TT

plus

): Use as remote display

ruments

Bi- irectional Sensor (Shown for ill

er a high level of precision is required.

5.3.3. Connections

Diagnostics. Connections can then be made as follows:

• Con

• Connect TACHTROL

plus

remote displays to T

section 3.3.2 and 3.3.3..

on ogic terminations as well as common per

t Analog output per section 3.3.2.

• Connect alarm D

3.4.2.

.4. TACHTROL 10 Programming &

s instrument will be set

and report on the displacement of the s

directions, direction mod

motion of the stage. Programming can be accomp

lay or TACHLINK.

106

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 132 133

Commenti su questo manuale

Nessun commento

Connect-Tek Transa PRO 17 Manuale delle Istruzioni Pagina 118

Commenti su questo manuale